RocketFish RF-500WPS2 - Manual (Page 8)

9 RF-500WPS2
Starting your computer
To start your computer:
1 Turn on the power supply by setting the power switch on the power
supply to the “I” (on) position.
2 Turn on your computer by pressing the power button on the front of
your computer.
Troubleshooting
If the power supply fails to function properly, check the following
before returning it for repair:
• Make sure that the power cord is plugged correctly into an AC power
outlet and into the power supply.
• Make sure that the power switch on the power supply is switched to the
“I” (on) position.
• Make sure that all power connectors are properly connected to all
components.
Specifications
Input voltage Minimum: 90 V
Normal: 100 V ~ 240 V
Maximum: 265 V
Input frequency Minimum: 47 Hz
Maximum: 63 Hz
Overcurrent protection Input fuse
Active PFC Power factor: equal to or greater than 0.99 @115V/60 Hz full load
Output +3.3V Maximum load 18.0 A Minimum load 0.5 A
+5 V Maximum load 18.0 A Minimum load 0.5 A
+12 V1 Maximum load 18.0 A Minimum load 1.0 A
+12 V2 Maximum load 18.0 A Minimum load 1.0 A
-12 V Maximum load 0.3 A Minimum load 0.0 A
+5 VSB Maximum load 2.5 A Minimum load 0.0 A
Note: +3.3 V and +5 V total output not to exceed 130 W
+12 V1 and +12V2, combined output not to exceed 36A
Rated wattage 500 W
Peak wattage 600 W
RF-500WPS2 09-1152_MAN_ENG_V2.fm Page 9 Tuesday, January 5, 2010 2:38 PM