RCA 900 MHz - Manual (Page 3)

4 5
INSTALLATION OF TRANSMITTER
INSTALLATION OF BATTERIES
1) Connect the supplied AC power adapter to an electrical
wall outlet.
2) Plug the AC power Adapter into the DC jack located on the
rear of the transmitter.
3) Locate the audio cord connected at the back of the transmit-
ter. The 3.5 mm plug provided can be used to connect the
transmitter to the headphone jack of any audio source.
If your equipment has a 1/4” size jack, use the adapter plug
included with the headphone.
For connection to RCA type phono jacks located on the back
of a TV, VCR or A/V receiver, use the “Y” adapter that is
included. Just insert the mini plug on the audio cord into the
jack on the adapter to convert the connector for this applica-
tion. Then insert the red and white RCA plug ends into the
equipment jacks marked “Audio Out” to make the audio
source connection (see diagram).
AC/DC
Adapter
Charge
Output
Jack
Audio
Cord
Green
LED
1) Open the battery compartment cover on the right side of the
headphone.
2) Insert two AA size Ni-Cd rechargeable batteries with the
correct polarity.
3) Replace the cover and you are ready to charge the batteries.
Battery
Door
STEREO JACK HEADPHONE
FM AM
LEFT
RIGHT
AUDIO
INPUT
Audio
Cord
1/4" adapter “Y” adapter
WHP150 MANUAL(1J1500 ) 6/10/99 11:28 AM Page 4