Roland VE-20 - Manual (Page 4)

4
Quick Start
1.
Getting ready
1
2
3
Connect your mic to the INPUT jack, and connect
the OUTPUT jacks to your mixer or recorder.
Move the rear-panel POWER switch to the ON
position. (The power will turn on.)
Before you make connections, make
sure that the input gain or volume of
your mixer or recorder is turned
down.
Adjust the input sensitivity.
1. Press the MENU button.
2. Press the cursor button ( ) to select MicSens.
3. Turn the SOUND knob to adjust MicSens.
At the ideal setting, the meter will occasionally reach the
far right (as shown below) when you sing loudly. If your
voice sounds distorted, lower the MicSens setting.
In order to use the VE-20 optimally, you’ll need to adjust the
input sensitivity.
Meter
Lit
• If you’re using batteries, insert them
before you continue.
“Installing Batteries” (p. 3)
• If you’re using an AC adaptor (BOSS
PSA-series; optional), connect it to
the DC IN jack.
• If you use a condenser mic that
requires phantom power, set the
Phantom Power parameter to the
On.
“Using a condenser mic
(Phantom Power)” (p. 16)
• If you’re using headphones,
connect them to the PHONES/LINE
jack.
When you turn on the power, a screen
like the following will appear. This is
called the “Play screen.”
The MicSens setting is stored in memory
even after the power is turned off, so you
won’t need to adjust it again unless you
want to use a different mic or a different
vocalist.
VE-20_e.book 4 ページ ２００９年７月３０日 木曜日 午後８時１３分