Roberts Gorden 1.800.828.7450 - Manual (Page 2)

Printed in U.S.A. C2RPBNA 1008 Rev A
Installation Code and Annual Inspections:
All installations and service of ROBERTS GORDON ® equipment must be performed by a contractor qualified in the installation and
service of equipment sold and supplied by Roberts-Gordon and conform to all requirements set forth in the ROBERTS GORDON ® manuals and all
applicable governmental authorities pertaining to the installation, service and operation of the equipment. To help facilitate optimum performance and
safety, Roberts-Gordon recommends that a qualified contractor annually inspect your ROBERTS GORDON
® equipment and perform service where
necessary, using only replacement parts sold and supplied by Roberts-Gordon.
Further Information: Applications, engineering and detailed guidance on systems design, installation and equipment performance is available
through ROBERTS GORDON ® representatives. Please contact us for any further information you may require, including the Installation, Operation and
Service Manual.
This product is not for residential use.
This document is intended to assist licensed professionals in the exercise of their professional judgement.
© 2008 Roberts-Gordon LLC All rights reserved. No part of this work covered by the copyrights herein may be reproduced or copied in any form
or by any means – graphic, electronic, or mechanical, including photocopying, recording, taping, or information
storage and retrieval systems – without written permission of Roberts-Gordon LLC.
Roberts-Gordon, LLC
1250 William Street
P.O. Box 44
Buffalo, NY 14240-0044 USA
Telephone: 716.852.4400
Fax: 716.852.0854
Toll Free: 800.828.7450
www.rg-inc.com
European Office:
Roberts Gordon Europe Limited
Telephone: +44 (0)121 506 7700
Fax: +44 (0)121 506 7701
Basic Remote
This control is used for make-up air
and space heating. The discharge
temperature of the heater remains
constant as selected on the selection
dial. The burner flame is modulated
by a discharge temperature control,
which is governed by the remote
temperature selector.
FAN ON/BURNER ON mode:
Heater can operate continuously for
building exhaust air replacement and
space heating by maintaining a
constant discharge temperature.
FAN ON/BURNER OFF mode:
The blower can operate without the
burner for summer ventilation.
NEMA 1 enclosure.
Remote Panel Descriptions
Standard Discharge Control
Remote (SDC)
This control is used for make-up air and
day/night heating of the building. The
discharge temperature of the heater
remains constant as selected on the
selection dial. The burner flame is
modulated by a discharge temperature
control, which is governed by the
remote temperature selector.
AUTO/WINTER mode:
Heater cycles on/off to maintain space
temperature as selected on the
thermostat.
ON/WINTER mode:
Heater can operate continuously for
building exhaust air replacement and
space heating by maintaining a constant
discharge temperature.
ON/SUMMER mode:
The blower can operate without the
burner for summer ventilation.
NEMA 1 enclosure.
Deluxe Temperature Control
Remote (DTC)
This control is used for make-up air
and total automatic “day/night” heating
of the building. A solid-state modulat-
ing room Selectrastat fully modulates
the burner flame to maintain space
temperature and compensate for
changing building heat losses or
gains.
AUTO/WINTER mode:
Occupied time: Heater can operate
continuously fully modulating Btu/h
output to maintain space temperature
as selected on the Selectrastat.
Unoccupied time: Heater cycles on/
off to maintain space temperature as
selected on the programmable ther-
mostat
(night setback).
ON/WINTER mode:
Heater can operate continuously fully
modulating Btu/h output to maintain
space temperature as selected on the
Selectrastat.
ON/SUMMER mode:
The blower can operate without the
burner for summer ventilation.
NEMA 1 enclosure.