AEG ELECTROLUX A 92700 GNW 0 - Manual (Page 42)

2 1
• Remove the door.
• Unscrew and move the pin to the oppo-
site side.
• Re-insert the door.
• Re-screw the lower hinge.
• Raise the appliance and install the ven-
tilation grille.
180°
• Unscrew the handle. On the opposite
side remove the hole covers by driving
a 3-4 mm drift or drill into them.
• Install the handle. Fit the handle on to
the opposite side by turning it on half
circle.
• Install the hole covers provided within
the accessory bag.
• Put the cabinet in position.
WARNING!
Reposition, level the appliance,
wait for at least four hours and
then connect it to the power sock-
et.
Do a final check to make sure that:
• All screws are tightened.
• The edges of the doors run parallel to
the side edge of the appliance.
• The magnetic seal adheres to the cabi-
net.
• The door opens and closes correctly.
WARNING!
If the ambient temperature is cold
(i.e. in Winter), the gasket may not
fit perfectly to the cabinet. In that
case, wait for the natural fitting of
the gasket.
42 www.aeg.com