Royal Sovereign RBC-1003BK - Manual (Page 10)

10
4. Test Run
Test the machine to set it to count your currency. Prepare at least five bills to test the machine. Place the bills on the hopper and run
the machine. If the machine counts the bills and there are no errors, it is ready to accept your currency.
If:
1. The bills are deformed
2. The machine is considerably slow
3. Error message is lit frequently
The hopper tension is too tight. To loosen this tension, please turn the Bill Thickness Adjuster one notch to the right (+).
Place the bills back into the hopper to test the machine again. If errors occur, adjust as necessary.
If:
1. The bills are flying out
2. The display shows a miscount
3. Error message is lit frequently
The hopper tension is too loose. To tighten this tension, please turn the Bill Thickness Adjuster one notch to the left (-).
Place he bills back into the hopper to test the machine again. If errors occur, adjust as necessary.
When the machine is running without any errors, it is ready to accept your currency.
5. Insert bills into the hopper to begin counting.