Raymarine DSM30 - Manual (Page 10)

10 DSM300 and DSM30 Installation Manual
A 3m-long cable is included for connecting your sounder module to a C Series or
hsb
2 PLUS (Pathfinder) Series display. Longer cables and connection cables for
other types of systems must be purchased separately.
Note: C Series displays have 4-pin connectors while the older hsb 2 PLUS Series displays
have a 3-pin configuration. This requires that you use a 4-pin to 3-pin adapter (Raymarine
part number R69081) when connecting a sounder module to an hsb
2 PLUS Series display.
This adapter is included with the DSM300 but must be ordered separately with a DSM30.
Select from the following cable options:
1.3 Selecting Sounder Module Mounting Location
DSM300 and DSM30 sounder modules are waterproof to IPX-7 is and is designed
to be mounted either above or below deck.
Mount the DSM where it is:
• protected from physical damage and excessive vibration
• protected from prolonged exposure to rain, salt spray and direct sunlight
• well ventilated
• as close to the transducer as possible
Do not locate the DSM:
• in the engine compartment
• on the main console
When planning the installation, the following should be considered to ensure
reliable and trouble free operation:
• Access: There must be sufficient space below the unit to enable cable con-
nections to the panel connectors, avoiding tight bends in the cable.
Cable Options
System Cable Part No.
E Series SeaTalk hs Network Cable, RJ-45, 1.5m
SeaTalk hs Network Cable, RJ-45, 5m
SeaTalk hs Network Cable, RJ-45, 10m
SeaTalk hs Network Cable, RJ-45, 20m
E55049
E55050
E55051
E55052
C Series C Series Network Cable, 4-pin-to-4-pin, 10m E65011
hsb 2 PLUS Series
(Pathfinder)
hsb 2 In Line Terminator
hsb 2 Splitter Cable
hsb 2 Adapter Cable, 4-pin to 3-pin
R58117
E55040
R69081