Ryobi YN200BND - Manual (Page 9)

9 - English
DANGER:
Do not use oxygen, combustible gases or bottled gases
as a power source for this tool. The tool will explode and
cause death or serious injury.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1 along with hearing and
head protection. Failure to do so could result in objects
being thrown into your eyes and other possible serious
injuries.
WARNING:
Disconnect the tool from the air supply before leaving the
work area, moving the tool to another location, or handing
the tool to another person. Failure to do so could result
in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:

Finish and Trim (interior and exterior)
 Decorative Trim
 Book Cases
 Baseboard
 Cabinets
 Case Backs
 Drawers
 Molding
 Mirror and Picture Frames
 Paneling
 Shoe & Base Moldings
 Staircases
 Upholstery Trim Panels
 Wainscoting
 Window Beading
 Chair Rail
 Furniture Frames
 Lattice Strip Molding
 Nailable Plastic Parts
 Crafts
OPERATION
WARNING:
Always wear eye protection. Eye protection does not fit all
operators in the same way. Make sure the eye protection
chosen has side shields or provides protection from flying
debris both from the front and sides.
PREPARING THE TOOL FOR USE
See Figure 2, page 15.
Under normal use conditions, the tool should be lubricated
before connecting the tool to an air supply. Add air tool oil
into the air fitting on the tool once daily with minimal use,
or twice a day with heavy use. Only a few drops of oil at a
time is necessary. Too much oil will only collect inside the
tool and will be noticeable in the exhaust cycle.
Before connecting the tool, check the air compressor
gauge to be sure it is functioning within the proper range of
70-120 psi.
NO-MAR NOSEPIECE
See Figure 3, page 15.
The no-mar nosepiece attached to the workpiece contact
of the tool helps prevent marring and denting when working
with softer woods.
WARNING:
Disconnect the tool from the air supply before removing
or replacing the no-mar nosepiece. Failure to do so could
result in serious personal injury.
The no-mar nosepiece can be removed by pulling it down
and away from the nose. To replace the no-mar nosepiece,
fit it into place over the workpiece contact and push up at
the back to reseat.
ADJUSTING THE EXHAUST
See Figure 4, page 15.
The adjustable exhaust on the end cap of the tool allows
the operator to direct the exhaust according to operator
preference. To adjust, turn the exhaust cap until the exhaust
blows in the desired direction.