BAUKNECHT DST 6460 ES - Manual (Page 18)

GB16
1. With a pencil, draw a mid line on the wall, up to the ceiling. This will make the installation procedure easier.
2. Fix the drilling template to the wall: The vertical mid line printed on the drilling template must correspond to the mid line drawn on the wall. The bottom
edge of the drilling diagram corresponds to the bottom edge of the hood.
3. Place the bottom support bracket on the drilling template so that it coincides with the dashed triangle. Mark and then drill the two external holes.
Note: always drill all the holes indicated on the template: the 2 upper holes are used to hook the hood in position, while the bottom ones (normally either
one central hole, or several lateral ones) are necessary to permanently secure the hood and ensure safety.
Remove the drilling diagram, insert the plugs in the holes and secure the hood support bracket using 2 5x45 mm screws.
4. Fit the hood to the bottom bracket.
5. Adjust the distance between the hood and the wall.
6. Adjust the horizontal alignment of the hood.
7. Secure the hood to the wall in its final position.
8. Fit the top cover using 7 3.5x9.5 mm screws
9. Connect the power supply.
Refit the grease filter/s and check that the hood is working properly.
INSTALLATION - ASSEMBLY INSTRUCTIONS