Radio Shack JEEP WRANGLER 60-202 - Manual

©2007. RadioShack Corporation.
All rights reserved. RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.
07A07
60-202
Printed in China
Jeep® Wrangler® Unlimited
Thank you for purchasing your Jeep® Wrangler® Unlimited
from RadioShack. Built to 1:14 scale, it can reach speeds of
650 feet per minute and comes in one of two frequencies (27
MHz or 49 MHz), so you can race with a friend. Please read
this user’s guide before installing, setting up and using your
Jeep.
What’s Included
Jeep Wrangler Transmitter
Jeep Antenna Tube AA Battery Tray
User’s Guide
Safety and Care
• Do not use your Jeep near transmitters with the
same frequency (27 MHz or 49 MHz).
• A nearby CB can interfere with your Jeep’s control.
If this happens, move the Jeep away from the CB.
• Never play with your Jeep in the street.
• Avoid high-impact collisions with people and
objects.
RF Emissions Information
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment causes harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult your local RadioShack store or an experienced technician for help.
If you cannot eliminate the interference, the FCC requires that you stop using
your Jeep. Changes or modifications not expressly approved by RadioShack
may cause interference and void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including
interference that may cause undesired operation.
Limited 90-day Warranty
This product is warranted by RadioShack against manufacturing
defects in material and workmanship under normal use for ninety
(90) days from the date of purchase from RadioShack company-
owned stores and authorized RadioShack franchisees and dealers.
For complete warranty details and exclusions, check with your local
RadioShack store.
RadioShack Customer Relations
300 RadioShack Circle
Fort Worth, TX 76102 04/04
Charge a 9.6 V battery pack (not supplied) before
installing.
1. Turn off your Jeep and transmitter.
2. Insert one 9V battery (not supplied) in the transmitter
battery compartment matching the polarity symbols (+
and -) marked inside.
3. Load and connect a fully-charged 9.6V battery pack or
battery tray with 6 AA batteries (neither supplied). The
connector fits only one way. Do not force it.
4. Replace the battery door and secure the latch.
Battery Notes:
• Use only fresh batteries of the required size and
recommended type. Use batteries of the same
types, capacities and chemistries.
• Do not burn or bury batteries.
• To keep motor heat levels down, let the Jeep cool
at least ten minutes between battery exchanges.
• If you do not plan to use the Jeep for a week or
longer, remove the batteries from both the Jeep
and transmitter.
• Position the battery connectors and wires so they
do not touch any moving parts.
Installing Batteries
Driving Your Jeep
1. Thread the Jeep’s antenna wire through the supplied antenna tube. Then,
insert the tube into the antenna tube holder on the Jeep’s body.
2. Make sure the transmmitter and the Jeep are on the same band. Turn on
the Jeep and transmitter. Your Jeep comes in 3 frequencies (Band ABC)
so you can play with friends. Set your Jeep and transmitter to a different
frequency than your friend’s.
3. Use the transmitter’s control levers to steer your Jeep.
4. Turn off the Jeep when you finish driving.
Forward
Stop
Reverse
Left Straight Right
Band ABC
ON/OFF
Battery
compartment
Latch
ON/OFF Band ABC
R / L – Turn toward R if the Jeep pulls to the left, or
toward L if it pulls to the right.
L / H – Switch to L when driving on rough
terrain, or to H when driving on smooth terrain.
lights when you turn on the Jeep.
Jeep® and the Jeep® grille design are registered trademarks of DaimlerChrysler Company, LLC. Jeep®
Wrangler® Unlimited and its trade dress are used under license from DaimlerChrysler. DaimlerChrysler
Company, LLC 2007.
60-202