Remington LNT-2 EN - Manual (Page 14)

14 107990
ELECTRIC CHAIN SAW
®
For more information, visit www.desatech.com
Filing Cutter Depth Gauges
The cutter depth gauge clearance is reduced
as cutters are sharpened. After every second
or third sharpening, reset cutter depth gauges.
1. Place depth gauge tool (.025") firmly
across top of two cutters. Make sure
depth gauge enters slot in depth gauge
tool (see Figure 21).
2. Use medium flat file. File depth gauge
level with depth gauge tool.
3. Remove depth gauge tool. With flat file,
round off front corner of cutter depth
gauge (see Figure 22).
After several hand filings, have authorized
service center or sharpening service machine
sharpen chain. This will insure even filing.
Figure 21 - Depth Gauge Tool On Chain
Flat File
Depth
Gauge
Slot
Figure 22 - Round Off Front Corner Of
Depth Gauge
Depth
Gauge
Tool
Depth Gauge
Front Corner
.025"
CLEANING AND
MAINTENANCE
Continued
REPLACING SAW CHAIN
Replace chain when cutters are too worn to
sharpen or when chain breaks. Only use
replacement chain noted in this manual.
Always include new drive sprocket when
replacing chain. This will maintain proper
driving of chain.
Note: For proper chain and
drive sprocket, see Replacement Parts and
Accessories, page 19.
TECHNICAL
SERVICE
You may have further questions about as-
sembling, operating, or maintaining this saw.
If so, contact our Technical Service Depart-
ment at 1-800-858-8501.
You can also visit our technical service web
site at
www.desatech.com .
SERVICE
PUBLICATIONS
You can receive an illustrated parts list free
of charge. Send a self-addressed stamped
envelope to address on back page of this
manual.
When writing, include model number and
serial number of saw. You will find these
numbers on saw motor housing decal.
STORAGE
If storing saw for more than 30 days, follow
steps below.
1. Drain oil tank.
2. Remove and clean guide bar and chain.
Clean guide bar and chain by soaking
in petroleum based solvent or mild soap
and water mixture.
3. Dry guide bar and chain.
4. Place chain in container filled with oil.
This will prevent rust.
5. Wipe a thin coating of oil over surface
of guide bar.
6. Wipe off outside of saw body. Do this
with soft cloth dampened with a mild
soap and water mixture.
7. Store chain saw
• in a high or locked place, out of
children’s reach
• in a dry place
• in a carrying case or with scabbard
over guide bar