Runco CL-810 CL-810 Ultra Cl-810 CineWide CL-810 / SDC-1 - Manual (Page 26)

Installation
14 Runco CL-810 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
3.2
Quick Setup Table 3-1 gives a quick overview of the CL-810 installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1 Choose a location for the projector 15
2 Install the CineWide (secondary anamorphic) lens (optional) 21
3 Mount the projector 22
4
If installing with an SDC-1, connect ONLY the SDC-1
output to the CL-810 and make all other connections to the
SDC-1; continue with Step 7
-- OR --
If installing without an SDC-1, connect signal sources to
the CL-810 and continue with Step 5 24
5 Connect external controller to RS-232 port (optional) 27
6
Connect other home theater components to 12-volt trigger
outputs (optional) 28
7 Apply power to the projector 28, 29
8 Change the OSD Language (optional) 29
9
For rear-screen and/or ceiling-mount installations, select
the proper picture orientation 29
10
Lens adjustments: projected image size (zoom), position
(shift) and focus 18, 30
11
Projector calibration: adjust the following for each input,
starting with Component 1; save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position
38 through 43
Note