Radio Shack TAD-759 - Manual (Page 8)

8
3. Insert the supplied AC adapter’s
barrel plug into the AC 9V jack on the
back of the base.
4. To mount the phone on a wall plate,
plug the other end of the modular
cord into the wall plate jack. Then,
with the power cord hanging over
the bracket, align the TAD’s keyhole
slots with the wall plate studs and
slide the TAD downward to secure it.
To mount the phone directly on a
wall, with the power cord and the
modular cord hanging over the
bracket, align the TAD’s keyhole
slots with the screws and slide the
TAD downward to secure it.
5. Slide the handset clip out of its
retaining slot, rotate it 180 ° , then
slide it back into its slot.
6. Plug one end of the supplied coiled
handset cord into the jack at the left
side of the base. Plug the other end
into the handset’s jack.
7. Place the handset on the base.
8. Plug the adapter into a standard AC
outlet.
When you first connect power,
_ _
flashes on the message counter as
the TAD runs a self-test. The TAD
beeps and
00 appears when the
test is complete.
SETTING THE DIALING
MODE
Set PULSE/TONE for the type of service
you have. If you are not sure which type
you have, follow these steps.
AC 9V Jack