RocketFish RF-TVMFM03 - Manual (Page 13)

13 Need help? Call 800-620-2790
RF-TVMFM03 TV Wall Mount
Step 6 Install the wall plate to a wood stud wall
Note: Any material (such as sheetrock) covering the wall must not exceed 5/8" (16 mm).
1 Locate the studs. Verify the center of the stud with an edge-to-edge stud finder.
2 At the wall height you determined in the previous step, align the wall plate (E) against the wall and make
sure that it is level. Use a pencil to mark the screw hole locations, then remove the wall plate.
Note: Your TV shifts left or right 7" (17.78 cm) from the home position to full extension.
3 Drill pilot holes to a depth of 3" using a 7/32" diameter drill bit.
4 Align the wall plate (E) with the pilot holes, then place the washers (U) over the holes in the wall plate (E).
Insert the lag bolts (V) through the washers, then tighten the lag bolts only until the washers (U) are pulled
firmly against the wall plate.
Caution: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (V).
You’ll need
3" (75 mm)
16"
40.6 cm
< 5/8"
(16 mm)
U (4)
Edge-to edge
stud finder
V (4)
Pencil Drill 7/32" wood
drill bit
1/2" socket
wrench Level