RCA D771 - Manual


D771
Universal Remote Control
Owner’s Manual
Care and Maintenance
• Keep the remote dry. If it gets wet, wipe it dry immediately.
• Use and store the remote only in normal temperature environments.
• Handle the remote gently and carefully. Don’t drop it.
• Keep the remote away from dust and dirt.
• Wipe the remote with a damp cloth occasionally to keep it looking
new.
• Modifying or tampering with the remote’s internal components can
cause malfunction and invalidate its warranty.
6-Component Universal Remote
Thank you for purchasing this RCA universal remote
control. This product is designed to operate a wide
variety of video and audio components. Please retain
this guide for future reference.
This universal remote control is already programmed for
most RCA, GE, and PROSCAN branded TVs, VCRs, DBS
systems (manufactured before 2003), and DVD players.
Note: For users of RCA and PROSCAN DBS products: Older
DBS models require that the INFO or MENU key on this
remote be used to make program selections. Use the
OK key for making program selections on newer RCA
and PROSCAN DBS models. If your satellite receiver
was purchased after 2003, programming the remote is
required.
Battery Installation and Information
Your universal remote requires 2 new AA alkaline
batteries (sold separately).
To install the batteries:
1. On the back of the remote, push down on the cover
and slide it off.
2. Insert the batteries, matching the batteries to the (+)
and (-) marks inside the battery case.
3. Slide the battery cover back into place.
Note: Reprogramming may be required after batteries are
replaced.
Battery Precautions:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
• Always remove old, weak or worn-out batteries promptly
and recycle or dispose of them in accordance with Local
and National Regulations.
Key Description
ANTENNA In TV
Mode, lets you
switch the source
of the video signal
from satellite signals
to an off-air antenna
or cable signal when
using the OUT
TO TV jack. In VCR
Mode, it functions as
a TV/VCR input key.
ARROWS Use the
navigation arrows
to move the on-
screen highlight up,
down, left, or right.
Using the arrows to
highlight a menu
item is also called
“pointing.”
CH + (UP)/ -
(dOWN) Use to
scan up and down
through the channels
in the current
channel list. If you
are in the program
guide or menu
system, use the
CH
+/- keys to page up
and down a screen
at a time. You can
also use the
CH +/-
keys on the top of
the digital satellite
receiver to change
the channel.
CLEAR Removes the on-screen displays and returns
you to normal viewing.
COMPONENT KEYS When programmed, these keys
are used to put the remote in a specific mode so that it
can control that component.
AUX1 ANd AUX2 Act as “wildcard” keys. They can
be programmed to control another TV, VCR, DVD,
satellite receiver, cable box, or an audio component.
Follow the direct entry programming instructions to
program these keys.
Note: The AUX1 key is pre-programmed with codes to
control a Dish Network digital satellite receiver.
dVd Puts the remote in DVD Mode.