Using multiple intercoms, Cautions and warnings, Fcc information – Radio Shack 43-3107 User Manual

Page 2: Care

Advertising
background image

USING MULTIPLE

INTERCOMS

You can set up several indoor intercoms for station-to-station
communication. Simply set CHANNEL A B C on the back of
each intercom to the same frequency as other stations with
which you want to communicate. For example, if you set all
stations to channel A, you can communicate with the other two
stations from any station. You could also set a station installed
in the kitchen to channel A, a station installed in the family room
to channel B, and a station installed in a bedroom to channel C.
Using the station installed in the kitchen, you can communicate
with the station in the family room by setting the channel
selector to B, or with the station in the bedroom by setting the
channel selector to C.

C

ALLING

A

NOTHER

S

TATION

Be sure the intercom stations you plan to use are turned on and
adjusted to the desired volume. Press CALL to sound a tone
alerting the person at the other station that you are about to
speak. The CALL indicator lights.

CAUTIONS AND

WARNINGS

• Dispose of old batteries promptly and properly. Do not burn

or bury them.

• Use only fresh batteries of the required size and

recommended type. Do not mix old and new batteries,
different types of batteries, or rechargeable batteries of
different capacities.

• If you do not plan to use the doorbell for two weeks or

longer, remove the batteries. Batteries can leak chemicals
that can destroy electronic parts.

• This product is equipped with a three-wire grounding-type

plug. This plug only fits into a grounding-type power outlet.
If you are unable to insert the plug into your AC outlet,
contact your electrician to replace your outlet.

• Be sure you install the stations at least 10 feet away from

each other. Placing the stations too close together
produces feedback (a squeal or howl from the speakers).
The stations can transmit up to 300 feet, including between
buildings, as long as they are connected to the same
power line transformer.

FCC INFORMATION

This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.

This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:

• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the dealer or an experienced radio TV technician for help.

Your system is ETL listed to UL standards and meets all applicable
FCC requirements.

NOTES

• There are two levels of low battery condition. The door bell

unit still works correctly at level 1. It does not work at level
2. When it reaches the first level, the indoor unit sounds an
alert tone for about five seconds and POWER blinks
periodically. If there is no key press before the replacement
of new batteries, the indoor unit sounds a beep tone every
minute. It can be stopped by pressing any key on the
indoor unit. If BELL is pressed at level 1, or the indoor unit
is reset at level 1 or 2, POWER returns to normal in about
two minutes, and another low battery signal is sent to the
indoor intercom. The indoor intercom sounds an alert tone
again for about five seconds, then sounds a reminder beep
every minute.

• The doorbell and indoor intercoms have three selectable

operation channels to prevent interference from similar
products nearby. Select the same channel for both the
doorbell intercom and the indoor intercom.

• If the doorbell occasionally sounds without anyone

pressing BELL, change the channel settings.

• If there is no voice communication between the doorbell

and the indoor intercom within about 10 seconds, the
intercom may be disabled and should be initialized by
pressing BELL again.

CARE

Keep the system dry; if it gets wet, wipe it dry immediately. Use
and store the system only in normal temperature environments.
Handle the system carefully; do not drop it. Keep the system
away from dust and dirt, and wipe it with a damp cloth
occasionally to keep it looking new.

Modifying or tampering with the system’s internal components
can cause a malfunction and might invalidate its warranty and
void your FCC authorization to operate it. If your system is not
performing as it should, take it to your local RadioShack store
for assistance.

WARNING: To reduce the risk of fire or shock hazard, do not expose this product to rain or moisture.

..

CAUTION

..

The lightning symbol is
intended to alert you to
the presence of
uninsulated dangerous
voltage within this
product’s enclosure
that might be of sufficient magnitude
to constitute a risk of electric shock.
Do not open the product’s case.

The exclamation symbol
is intended to inform you

that important operating

and maintenance instruc-

tions are included in the
literature accompanying

this product.

!

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT REMOVE COVER OR BACK. NO
USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.

RadioShack Corporation
Fort Worth, Texas 76102

11A02

AO0133ABA1

Printed in China

Limited Ninety-Day Warranty

This product is warranted by RadioShack against manufacturing defects in material and workmanship un-
der normal use for ninety (90) days from the date of purchase from RadioShack company-owned stores
and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, RadioShack
MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE OF MER-
CHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE
DURATION OF THE WRITTEN LIMITED WARRANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED
HEREIN, RadioShack SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO CUSTOMER OR ANY
OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DI-
RECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY
BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING
FROM INCONVENIENCE, LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDI-
RECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of
incidental or consequential damages, so the above limitations or exclusions may not apply to you.
In the event of a product defect during the warranty period, take the product and the RadioShack sales re-
ceipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, unless otherwise
provided by law: (a) correct the defect by product repair without charge for parts and labor; (b) replace the
product with one of the same or similar design; or (c) refund the purchase price. All replaced parts and
products, and products on which a refund is made, become the property of RadioShack. New or recondi-
tioned parts and products may be used in the performance of warranty service. Repaired or replaced parts
and products are warranted for the remainder of the original warranty period. You will be charged for repair
or replacement of the product made after the expiration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, acci-
dent, misuse, improper or abnormal usage, failure to follow instructions, improper installation or mainte-
nance, alteration, lightning or other incidence of excess voltage or current; (b) any repairs other than those
provided by a RadioShack Authorized Service Facility; (c) consumables such as fuses or batteries; (d) cos-
metic damage; (e) transportation, shipping or insurance costs; or (f) costs of product removal, installation,
set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to
state.

RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102

12/99

Advertising