Rockford Fosgate P600..I bd - Manual (Page 12)

12
S
PECIFICATIONS
Specifications subject to change without notice
MODEL- PUNCH P325.1 P600.1 bd
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4 Load Mono 175 Watts x 1 325 Watts x 1
2 Load Mono 325 Watts x 1 600 Watts x 1
Dimensions: Height 2.1" (5.33cm) 2.1" (5.33cm)
Width 11" (27.94cm) 11" (27.94cm)
Length 11.7” (29.72cm) 13.7" (34.80cm)
Amplifier Fuse Rating (Amp/Type) (1) 40A / ATC (2) 30A / ATC
Battery Fuse Rating (Amp) External 40A 60A
(Not Supplied)
Signal-to-Noise Ratio >80dB A-weighted @ 2Vrms
Crossover Slope 12dB/octave Butterworth
Crossover Frequency (P325.1) variable from 40Hz to 400Hz
Crossover Frequency (P600.1 bd) variable LP (low pass) from 35Hz to 250Hz
Frequency Response (P325.1) 20Hz to 20kHz ±0.5dB
Frequency Response (P600.1 bd) 20Hz to 250Hz ±3dB
Bandwidth (P325.1) 20Hz to 200kHz ±3dB
Slew Rate 30 Volts/µS
IM Distortion (IHF) <0.05%
Signal Voltage Adjustment Range Variable from 150mV to 4V (RCA Input)
Protection (P325.1) NOMAD - Internal analog-computer output protection
circuitry limits power in case of overload, plus short
protection.Thermal switch shuts down the amplifier
in case of overheating.
Protection (P600.1 bd) Short circuit protection shut downs the amplifier in
case of very low impedance or shorted speaker wires.
Thermal switch shuts down the amplifier in case of overheating.
Equalization (45Hz Punch Bass) Variable from 0dB to +18dB @ 45Hz
Input Impedance 10k ohms
Infrasonic Filter (P600.1 bd) Selectable 12dB/Octave, -3dB @ 28Hz
These specifications are Amplifier Power Standard CEA-2006 Compliant
A
CCESSORIES
PUNCH Capacitors
Maintain the power you need to your Punch Amplifier.
PUNCH Install Kits
A variety of install kits are available to help you install your Punch amplifier like a professional.
Para-Punch Remote Bass Control
This adds an adjustable center frequency control with the adjustable boost control.
See our web site for other accessories to help you get the most out of your system.
www.rockfordfosgate.com