Roland VS-700R - Manual (Page 17)

17
Connecting Recording Equipment
fig.VS-700-rec02-digi-e.eps
Howling could be produced depending on the location of microphones relative to speakers. This can be
remedied by:
1. Changing the orientation of the microphone(s).
2. Relocating microphone(s) at a greater distance from speakers.
3. Lowering volume levels.
Connections to the Digital Connectors
VS-700R Rear Panel
Connecting a Digital Audio Source
If you want to digitally connect a DAT or similar device, connect its output connector (e.g., DIGITAL OUT connector) to the VS-700R's DIGITAL IN
connector.
If you're connecting an ADAT device,
connect it to the ADAT connector.
A maximum of eight channels can be input
Using an
AES/EBU
connector
Using
a coaxial
connector
The DIGITAL 1 coaxial connector and AES/EBU connector
are a mutually exclusive selection. To make your choice, go
to SONAR’s “Tools” menu, open “ VS-700,” select the “MIC
PRE” tab, and make the desired setting in the “DIGITAL 1
INPUT” field.
VS-700R_e1.book 17 ページ ２０１０年６月１５日 火曜日 午後４時５９分