Robic Timer SC-554 - Manual (Page 3)

Page x of y
Rev 02 05/04/05
Setting NORMAL TIME and ALARM TIME
While in NORMAL TIME mode, press and hold “F” for 2-3 seconds. “SET” indicator appears. Alarm
hours will begin flashing. Advance Alarm Hours by pressing or holding “C”. After setting Alarm Hours,
Press “E”. Alarm Minutes will appear flashing. Advance by pressing or holding “C”.
Repeat the setting process for Seconds >>>> Hours >>>> Minutes >>>> Month >>>> Date >>>> Day of
the Week >>>> 12/24 Hour Option >>>> and back to Alarm Hours.
Pressing “F” at any time, will automatically exit the setting procedure. “SET” indicator disappears.
Time of Day and Alarm Time will both be presented in the AM/PM or 24 Hour format chosen. “A” or “P”
will appear in the AM/PM format.
Using the Daily Alarm and Hourly Chime
The Alarm can be armed (set to go off) to sound once per day. The Alarm symbol ((((
•)))) will appear
when the alarm is armed.
The Hourly Chime can be armed to sound one (1) beep at the top of each hour. The Chime indicator (
♠ )
will appear when the chime is armed.
While your SC-554 is in NORMAL TIME mode, press “C” to arm, or disarm your alarm and chime. The
sequence is:
(1) Alarm ON, Chime OFF
(2) Chime ON, Alarm OFF
(3) Alarm ON, Chime ON
(4) Alarm OFF, Chime OFF
When armed, the alarm will sound when the Alarm Time coincides with Time of Day. You may silence
the alarm by pressing any pushbutton.
PART III
CHRONOGRAPH MODE (Stopwatch)
The SC-554’s chronograph is a digital stopwatch with 1/100 second resolution, which will present timing
in any of three (3) different options.
From NORMAL TIME, press “E” once to enter the CHRONOGRAPH mode. Chrono indicator “CHR”
and all zeros should appear. If the display does not show all zeros, reset the chrono by:
If RUN appears, press “A” to STOP and “B” to RESET.
If STOP appears, simply press “B” to RESET to all zeros.
“LAP” Chrono will display the Interval of time from your previous readings. Each time a reading is taken,
the timer begins from zero.
“SPLIT” Chrono will display the Accumulation of time from the start of the event. Each time a reading is
taken, the timer shows the Total amount of time accrued.
“LAP/SPLIT” Chrono will display the Lap Time in the upper row and the Split Time in the lower row of
the display.
General Operation
Select from the LAP, SPLIT or LAP/SPLIT options by pressing “C”.