Assembly – Ryobi DP102L User Manual
Page 13
12
13
UNPACKING
This product requires assembly.
n
Carefully remove the tool and any accessories from the
box. Place it on a level work surface.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
n
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
n
Do not discard the packing material until you have
carefully inspected the tool, identified all loose parts,
and satisfactorily operated the tool.
n
If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
tool until the missing parts are replaced. Failure to heed
this warning could result in possible serious personal
injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
ASSEMBLY
Fig. 5
ATTACHING COLUMN ASSEMBLY TO BASE
See Figure 5.
n
Place the base on a flat surface. Align screw holes in the
column assembly with screw holes in the base.
n
Place a hex bolt in each hole and tighten using an adjust-
able wrench.
BASE
HEX BOLT
COLUMN
ASSEMBLY