Rangemaster Ceramic Hob - Manual (Page 7)

7
INSTALLATION
SERVICING
Before doing any servicing, disconnect the
appliance from the power supply.
7) Replacing parts
To replace internal components it is necessary to
remove the appliance from the worktop. Turn the
hob over, loosen the screws and remove the base.
It is possible to work on the plates, controls, clamps
and input cable.
When replacing the input cable, keep the
“earth” conductor longer than “live” ones.
Follow the advice given in “Electrical
connection” section.
To reassemble the appliance repeat the inverse
process.
5) Technical Data
Element W
Ø 145 mm element 1200
Ø 180 mm element 1700
Voltage 230 - 240/400 - 415 V
3N~
Frequency
50/60 Hz
Tot. Rating 5800 W
Before leaving the factory, this appliance will have been tested and regulated by expert and specialized
personnel in order to guarantee the best performances.
Only qualified engineers should carry out any repairs or adjustments. Do not use re-conditioned or
unauthorized controls.
If repairs or adjustments are required, contact our service provider on 0845 6035312 specifying the type
of fault and the model of the appliance. This information is printed on the data label on the base of the
hotplate.
Please fill in the following information so that you have it to hand if you have to call for service.
MARK: .............................................................................
MODEL: ...........................................................................
SERIES: ...........................................................................
TECHNICAL ASSISTANCE AND SPARE PARTS