Recoton/Advent AW770 - Manual (Page 7)

7
Note: If the light does not flicker, confirm secure connection of the AC Adapter. If
the light still does not flicker, confirm secure connection to the audio source output.
If, there is still no response, leave the Output Level Control Wheel completely to the
left (as shown) and see the following Note.
Note: If the transmitter is connected to a variable output (i.e. headphone jack, TV
audio out) on the audio source, leave the Output Level Control Wheel turned all the
way to the left (as shown) and adjust the volume on the audio source up or down
as necessary to make the Audio Level Indicator Light flicker intermittently. If you
are unclear as to the kind of output (variable or fixed) you are using, please see
MORE HELPFUL INFORMATION below.
TUNE THE HEADPHONES
Adjust the headphones as follows:
1. Disconnect the Charge Cable (S) from the
headphone Charge Input Jack (D) if connected.
2. Use the headphone Power ON/OFF
Button (E) to turn the headset “ON”
(button pushed to the “in” position).
3. Turn the Tuning Control Wheel (G) until
the Tuning Indicator Light (H) illuminates
red, indicating the headset is tuned
to the signal from the transmitter.
4. Adjust Volume (F) as desired.
Note: After fine tuning, interference in the form of static and/or distortion can some-
times be heard. If this occurs, confirm the transmitter/headphone adjustments and indi-
cators. If the problem persists, refer to the TROUBLESHOOTING section of this manual.
MORE HELPFUL INFORMATION
About Fixed-Level Outputs
A fixed-level, or line-level audio output is considered ideal since it provides an audio
signal unchanged by adjustments to the audio source (stereo, etc.) volume control.
Hint: Fixed-level audio outputs from stereo receivers/amps will typically be desig-
nated as Tape, Tape 1, and Tape 2 outputs, DAT (digital audio tape) outputs, VCR
audio output connections, and auxiliary audio outputs. Tape, Tape 1, Tape 2 and
DAT outputs are usually marked as ‘TAPE OUTPUT,’ ‘TAPE OUT,’ ‘TAPE REC,’ or
TAPE RECORD.’ Jacks designated for phono, CD, LD, DVD or tape playback (PB) are
inputs and will not work for purposes of installing the transmitter.
Fixed-level outputs from TVs are usually marked as ‘Constant,’ ‘Fixed,’ or ‘Select.’ If
they are not marked as such, they are probably variable outputs (see “About
Variable-Level Outputs,” on Page 8).
Outputs from VCRs are almost always fixed.
STEREO
R
Tuning Indicator
Light (H)
Tuning
Control
Wheel (G)
POWER
L
Charge Input
Jack (D)
Charge
Cable (S)
Volume
Control
Wheel (F)
Power
On/Off
Button (E)