Raymarine L470 - Manual (Page 32)

26
Operating Instructions
Fig. 3-1
Display
Panel
3 – Operating Instructions
In this section of the manual, we will explain how to operate the unit.
(Setup instructions are included in the next section.) Below is a drawing
of the display unit.
Controls on Display Panel
The FishFinder is designed to be easy to use while the boat is moving.
You can steady your hand by gripping the right side of the display with the
fingers of your right hand. This will allow you to use your right thumb to
press the buttons on the display.
Notice that some of the buttons can be used in two ways. They do one job
during a normal display, and a different job when you are setting up the
unit. In this section, we will use symbols like this –
PWR and SETUP – to
indicate the buttons on the front of the unit.
PWR This button turns the power on and off.
To turn on the power – Press once to turn the power on.
To enter the Lamp/Contrast Menu – To bring up the
Lamp/Contrast Menu in any operating mode, press the
PWR
key for a moment, then release it.
To turn off the power – If you press and hold the button,
the display will say “Powering Off.” If you hold the button
for more than 3 seconds, the display unit will switch off.
PWR
SETUP
CLEAR
ZOOM
BOT
LOCK
A-SCP
FISHFINDER
L470
Raymarine
Display
area
Power button
Page control
pad
Setup button
Clear button
Zoom button
A-Scope button
Bottom Lock
button