Royal Sovereign RSL-2701 - Manual (Page 11)

3. Film is jammed on the rollers.
1) First press reverse button.
2) Pull jammed film slowly to the back of the machine.
3) If you feel film is jammed again, stop pressing reverse button.
4) press run button, and then pull jammed film to the back of the machine.
4. Main PCB is defective
Replace Main PCB with new one according to How to replace Main PCB
only when all of the above mentioned Emergency switch, Frame paper guide,
Safety cover switch, motor wire connectors, main motor and film are normal.
5. Replace Motor with new one according to How to replace the Motor.
2.4 No Main Power
1. Main power wire is not connected with Main Switch
2. Main fuse is disconnected.(except RSL-380)
3. Wire-AC IN is not connected with Main PCB.(except RSL-380)
4. Transformer is defective.
Before troubleshooting, be sure to disassemble the Right cover ,
the Left cover and the FRAME Rear.
Refer to how to replace each component for the
disassembly of them.
1. Main power wire is not connected with Main Switch.
1) Check if the Main power wires are connected correctly.
<RSL-2701/2701U> <RSL-380>
9
MEASURES
CAUSES
MAIN SWITCH
MAIN SWITCH
connecting part