Rockford Fosgate FFC69 - Manual (Page 4)

4
I
NSTALLATION
Example of 6" x 9" rear-deck installation
Speaker
Rear Deck
Mounting
Ring
Cut-Out
Grille
Example of standard
door installation
Mounting Hole,
Cut-Out
Mounting Ring
Grille
Speaker
S
PECIFICATIONS
FEATURES
• Cone (polypropylene)
• Surround (foam)
• Tweeter (polyethermide)
MOUNTING
1. Determine where the speakers will be mounted. Ensure an area large enough for the speaker to
mount evenly. Be sure that the mounting location is deep enough for the speaker to fit; if mount-
ing in a door, operate all functions (windows, locks, etc.) through their entire operating range to
ensure there is no obstruction.
2. Refer to the specification chart to determine the proper diameter hole to cut for your speaker
model.
3. Using the plastic mounting ring as a template, mark the locations for the mounting screws. Drill
the holes with a 1/8" bit.
4. Feed the speaker wires through the cutout and the plastic mounting ring (from the flat side) and
connect to the speaker terminals. Be sure to observe proper polarity when connecting the wires.
The speaker's positive terminal is indicated with a "+".
5. Fit the ring and speaker to the cutout. Mount them using the enclosed screws. Fit the grille
inside the ring and press gently, but firmly, into place.
Model FFC65 FFC69
Nominal Diameter (inch) 6.5 6 x 9
Nominal Diameter (mm) 165.1 152.4 x 228.6
Description 3-way 3-way
Nominal Impedance (ohms) 4 Ω 4 Ω
Frequency Response 35Hz-22kHz 30Hz-22kHz
Sensitivity (SPL@1w/1m) 88dB 91dB
Power Handling (Watts RMS/Peak) 50/100 75/150
Installation
Speaker Grilles X X
Mounting Diameter (inch) 5-5/8 6-1/2 x 9-1/4
Mounting Diameter (mm) 142 165 x 235
Mounting Depth (inch) 2-1/2 3
Mounting Depth (mm) 64 76
Specifications subject
to change without
notice