Roland COLOR CAMM PNC-5000 - Manual (Page 14)

12
6 Printing and Cutting Samples
Removing the blank space surrounding a picture
Adding color to a border
6 Printing and Cutting Samples
Material
Material
Stick
Stick
Cutting outline
Cutting outline
Correcting Line Pitch
Line pitch: Correct Line pitch is too narrow, and ink
overlaps.
Line-pitch correction:
Set to “Wide” or “Extra Wide”
Line pitch is too wide, and spaces
appear between lines.
Line-pitch correction:
Set to “Narrow” or “Extra Narrow”
How to Correct Line Pitch
Hold down the SETUP key and switch on the
power.
Pressing the
or key changes the pattern
in which the PAUSE LED, BASE POINT SET
LED, and ALIGN POINT SET LED light up.
This pattern indicates the current line pitch.
Use the table at right as a reference to press the
and keys and make the desired line-
pitch setting. After making the setting, press
the SETUP key (the SETUP LED will light
up). (If material is not loaded, be sure to load
one before pressing the SETUP key.) The
setting that has been made is stored in memory
even after the power is switched off. To
change the setting, simply repeat the procedure
just described.
* Distance accuracy cannot be guaranteed when
line-pitch correction has been performed.
Line-pitch
correction
Extra wide Extra narrow Narrow Wide
Default
(no correction)
LED
display
pattern
Lighted
Lighted
Lighted
Dark Dark Dark
Dark Dark Dark
Dark Dark
Blinking
Blinking Blinking
Blinking