Ryobi BGH615 - Manual (Page 6)

Page 6
CAUTION:
Keep the cord away from the grinding area and position
the cord so that it will not be caught on material, tools,
or other objects.
GROUNDING INSTRUCTIONS
In the event of a malfunction or breakdown, grounding
provides a path of least resistance for electric current to
reduce the risk of electric shock. This tool is equipped with
an electric cord having an equipment-grounding conduc-
tor and a grounding plug. The plug must be plugged into a
matching outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
Do not modify the plug provided. If it will not fit the outlet,
have the proper outlet installed by a qualified electrician.
Improper connection of the equipment-grounding conductor
can result in electrical shock. The conductor with insulation
having an outer surface that is green with or without yellow
stripes is the equipment-grounding conductor. If repair or
replacement of the electric cord or plug is necessary, do
not connect the equipment-grounding conductor to a live
terminal.
Check with a qualified electrician or service personnel if the
grounding instructions are not completely understood, or if
in doubt as to whether the tool is properly grounded.
Repair or replace a damaged or worn cord immediately.
This tool is intended for use on a circuit that has an outlet
like the one shown in figure 1. It also has a grounding pin
like the one shown.
ELECTRICAL CONNECTION
Your Ryobi Bench Grinder is powered by a precision built
electric motor. It should be connected to a power supply
that is 120 volts, 60Hz, AC only (normal household current).
Do not operate this tool on direct current (DC). A substantial
voltage drop will cause a loss of power and the motor will
overheat. If the machine does not operate when plugged
into an outlet, double check the power supply.
Fig. 1
COVER OF GROUNDED
OUTLET BOX
EXTENSION CORDS
Use only 3-wire extension cords that have 3-prong ground-
ing plugs and 3-pole receptacles that accept the tool's plug.
When using a power tool at a considerable distance from the
power source, use an extension cord heavy enough to carry
the current that the tool will draw. An undersized extension
cord will cause a drop in line voltage, resulting in a loss of
power and causing the motor to overheat. Use the chart
provided below to determine the minimum wire size required
in an extension cord. Only round jacketed cords listed by
Underwriter's Laboratories (UL) should be used.
Length of Extension Cord
Wire Size (A.W.G.)
Up to 25 feet 16
26-50 feet 16
51-100 feet 16
When working with the tool outdoors, use an extension cord
that is designed for outside use. This is indicated by the
letters WA on the cord's jacket.
Before using an extension cord, inspect it for loose or
exposed wires and cut or worn insulation.
ELECTRICAL
n Carefully remove all parts from the shipping carton.
n Lift the bench grinder from the carton and place it on a
level work surface.
n Do not discard the packing materials until you have care-
fully inspected the machine, identified all loose parts, and
satisfactorily operated your bench grinder.
n Examine all parts to make sure no breakage or damage
has occurred during shipping.
n If all parts have been included, proceed to assembly.
UNPACKING
n If any parts are damaged or missing, do not attempt to
plug in this tool or turn it on until the damaged or missing
parts are obtained and installed correctly.
n Contact your nearest Ryobi dealer or call 1-800-525-2579
in the United States or 1-800-265-6778 in Canada for
assistance if any parts are missing or damaged.
WARNING:
If any parts are missing do not operate this machine until
the missing parts are replaced. Failure to do so could
result in possible serious injury.
GROUNDING
PIN