Technical data, Installation, Closing the door – AEG ELECTROLUX AGS 1921 User Manual

Page 78: Location

Advertising
background image

Problem

Possible cause

Solution

dEMo appears on the Dis-

play.

The appliance is in demonstra-

tion mode (dEMo).

Keep pressed approximately 10

sec. the OKbutton since a long

sound of buzzer is heard and the

Display shut off for a short while:

appliance start works regularly.

Closing the door

1.

Clean the door gaskets.

2.

If necessary, adjust the door. Refer to "Installation".

3.

If necessary, replace the defective door gaskets. Contact the Service Center.

TECHNICAL DATA

Dimension of the recess

Height

1600 mm

Width

600 mm

Depth

630 mm

Rising Time

35 h

Voltage

230-240 V

Frequency

50 Hz

The technical information are situated in the rating plate on the internal left side of the

appliance and in the energy label.

INSTALLATION

WARNING!

Read the "Safety Information" carefully for your safety and correct operation of the appli-

ance before installing the appliance.

Location

The appliance should be installed well away from sources of heat such as radiators, boilers,

direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To

ensure best performance, if the appliance is positioned below an overhanging wall unit, the

minimum distance between the top of the cabinet and the wall unit must be at least 100

mm . Ideally, however, the appliance should not be positioned below overhanging wall

units. Accurate levelling is ensured by one or more adjustable feet at the base of the cabi-

net.

If the cabinet is placed in a corner and the side with the hinges facing the wall, the distance

between the wall and the cabinet must be at least 10 mm to allow the door to open

enough so that the shelves can be removed.

78

Technical data

Advertising