RCA ViSYS 25110 - Manual (Page 19)

1
Ringer Tone
1. Press the Prog/Flash button until RINGER TONE 1 shows in the display.
2. Use the CID/Vol ( 5 or 6 ) buttons or the handset number pad to select
and listen to a ringer tone. There are seven ringer tones to choose from. The
default setting is 1.
3. Press the Prog/Flash button to confirm. You will hear a confirmation tone.
Ringer Volume
1. Press the Prog/Flash button until RINGER VOL 1HI shows in the display.
2. Use the CID/Vol ( 5 or 6 ) buttons or the handset number pad to select 1 (HI),
2 (LOW), or 3 (OFF). The default setting is 1HI.
3. Press the Prog/Flash button to confirm. You will hear a confirmation tone.
Default Setting Selection
1. Press the Prog/Flash button until DEFAULT 1NO shows in the display.
2. Use the CID/Vol ( 5 or 6 ) buttons or the handset number pad to select 1 (NO),
or 2 (YES). The default setting is 41NO. If you choose NO, the current settings
remain. If you choose YES, the unit resets to the factory defaults.
3. Press the Prog/Flash button to confirm.
Connections & Setup