Preamplifier – Roksan Audio M series --1 User Manual

Page 8

Advertising
background image

Roksan Audio ltd

Caspian Preamplifier User Manual

CLASSIFICATION: General Use

Version 2.03

All specifications are liable to change without notice. E&OE

Page 8

ENGLISH

If you suspect that your ROKSAN Caspian preamplifier is not operating properly, you should check all the
connections carefully. Phono plugs should be fully inserted- a frequent cause of problems is that Phono plug
surrounds do not make proper contact. Below are some commonly encountered problems with suggestions for
possible cure. The list is not exhaustive: If you have any unresolved problems, please consult your appointed
ROKSAN dealer or distributor.

SYMPTOM LIKELY

CAUSE SUGGESTED

REMEDY

No power

AC Mains lead not inserted properly
Unit not switched on at rear panel
IEC mains inlet fuses blown

Ensure AC Mains lead is fully inserted
Switch unit on at rear panel
Replace with identical fuse type and
rating and try again (only once)

No output on one or both
channels







Very low sound output

Amplifier in stand-by mode (MODE light
GREEN)

Missing or bad input signal connection

Wrong input selected

Tape Monitor selected

Amplifier set in MUTE position

Press MODE button to set amplifier in
operational mode (MODE light RED)

Check all input connections

Select correct input, ascertain source is
working
Deselect Tape Monitor

Deselect MUTE (check volume setting
first)

Hum from speakers

Incorrect Grounding

Poor choice of interconnect cables

Check Mains polarity and grounding on
all connected equipment
Change the interconnect cables









There are no user-serviceable parts inside your Caspian preamplifier. If a fault should develop, refer any
servicing to your appointed ROKSAN dealer, distributor or approved service agent.

Your ROKSAN Caspian preamplifier is guaranteed against any defect in materials and workmanship for a period
of two years from the date of purchase.

This guarantee only becomes effective if the warranty card is validated by the ROKSAN retailer from whom the
equipment was purchased and returned to ROKSAN within 28 days of purchase.
This guarantee excludes:
1. Damage caused due to accident, missuse, neglect and incorrect installation, adjustment or repair.
2. Liability for damage or loss during transit from the retailer or purchaser to ROKSAN or its authorised

distributor for the purposes of repair or inspection.


Carriage costs to ROKSAN shall be borne by the consignor.

All claims under this guarantee must be made through an authorised ROKSAN retailer.

If equipment returned for repair to ROKSAN is found on inspection to comply with the product specification
ROKSAN reserves the right to make a charge for examination and return carriage.

Unauthorised servicing will void this guarantee.



T R O U B L E S H O O T I N G

C a s p i a n

Preamplifier

G U A R A N T E E

C a s p i a n

Preamplifier

Advertising