RedMax EBZ7001RH - Manual (Page 38)

38
9. Maintenance
English
(1) Three Bolts
(2) Spark Arrester
■ AIR INLET NET
• Blowing air is taken in from the air inlet net. When air
flow has dropped down during operation, stop the
engine and inspect the air inlet net for blocking by
obstacles.
• Note that failure to remove any such obstacles may
result in the engine becoming overheated and
damaged.
(1) Net
Never use the blower without the net of the blower.
Before each use, check that the net is attached in
place and is free from any damage.
■ IGNITION COIL AIR GAP INSPECTION
• If the gap is out of standard or when installing the
coil or rotor, adjust the air gap between the ignition
coil and the iron core of the rotor.
Air Gap:
0.40mm (0.35 ~ 0.45mm)
0.016" (0.014 ~ 0.017")
(1) Rotor
(2) Ignition coil
■ SHOULDER STRAP
• If the shoulder strap is damaged it may break during
use, thus causing the product to fall and resulting in
personal injury. Follow the instructions below to
replace the shoulder strap with new one.
• Pass the upper end of the strap through the hanger,
making the FLAPPED SIDE OUTSIDE.
• Put the end of the strap through the ring on the
strap, and then push the ring toward the hanger as
close as possible.
(1) Ring
WARNING
IMPORTANT
F22
F21
(1)
F20