Ryobi Drill Press - Manual (Page 6)

6
– English
3 Muffler
Never use a machine that
has a defective muffler.
Check regularly that the
muffler is secured to the
engine body.
SAFETY INSTRUCTIONS
GENERAL SAFETY INSTRUCTIONS
IMPORTANT INFORMATION!
Do not use the power cutter until you have read the
entire contents of this Operator’s Manual.
All servicing, in addition to the points listed in the
section ”
Control, maintenance and service of the
power cutter’s safety equipment”, should be carried
out by trained service specialists.
• Use the equipment recommended in the chapter ”Personal
safety equipment”.
• Never use the machine when you are tired, under the
influence of medicines/drugs or alcohol.
• Do not lend the power cutter to anyone without providing this
Operator’s Manual. Ensure the person using the power cutter
understands the information in this Operator’s Manual.
Transport and storage
• Store the power cutter under lock and key so that it’s out of
reach for children and unauthorised persons.
• Do not store or transport the power cutter with the cutting
blade fitted.
!
!
WARNING! Check that the cutting blade is
fitted correctly and does not show signs of
damage. A damaged cutting blade can cause
personal injury.
WARNING! Never use a power cutter with
defective safety equipment. The power
cutter’s safety equipment should be checked
and maintained as described in this
Operator’s Manual. If your power cutter does
not meet any of these controls you should
contact your service workshop.
5 Blade guard for the cutting blade
Never use a defective blade
guard or a blade guard that is
not fitted correctly.
4 Throttle lock
1 Make sure the throttle
control is locked at the
idle setting when you
release the throttle lock.
2 Press the throttle lock and
make sure it returns to its
original position when you
release it.
3 Check that the throttle
control and throttle lock
move freely and that the
return springs work
properly.
4 Start the power cutter and
apply full throttle. Release
the throttle control and
check that the blade stops
and remains stationary. If
the blade rotates when
the throttle is on idle
setting you should check
the carburettor idle
adjustment. See the
section on
”Maintenance”.