ZANKER ZKK 8023 - Manual (Page 19)

Ventilation requirements
The airflow behind the
appliance must be suffi-
cient.
50 mm min.
200 cm
2
min.
200 cm
2
Installing the appliance
Caution! Make sure that the mains cable can
move freely.
Do the following steps:
x
x
If necessary cut the adhe-
sive sealing strip and then
apply it to the appliance
as shown in figure.
1
2
Install the appliance in the
niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture.
Push the appliance in the
direction of the arrows (2)
against the cupboard on
the opposite side of the
hinge.
44mm
4mm
Adjust the appliance in the
niche.
Make sure that the dis-
tance between the appli-
ance and the cupboard
front-edge is 44 mm.
The lower hinge cover (in
the accessories bag)
makes sure that the dis-
tance between the appli-
ance and the kitchen furni-
ture is correct.
Make sure that the clear-
ance between the appli-
ance and the cupboard is
4 mm.
Open the door. Put the
lower hinge cover in posi-
tion.
I
I
Attach the appliance to
the niche with 4 screws.
19