Russound R275HC - Manual (Page 4)

4
1 2 3 4 3
6 5 8
Power Switch: Turns the amplifier on/off. This
switch does not disconnect the main power feed
from the amplifier; this requires that the power cord
be unplugged from the outlet.
Low Cut (High Pass) Switch: Enables/disables the
filter that reduces very low frequency energy and
protects autoformer-based volume control/speaker
selectors. When “on,” the filter is set to -3dB at 40
Hz. When off, the frequency response is flat from
20Hz to 20kHz.
Gain Controls: Left and Right gain controls inde-
pendently adjust the sound level for each channel.
When used in the bridged mode only the Left control
is used.
Loop Output: The loop output is a passive
passthrough of the line input. These jacks can be
used to daisy chain the input signal to another
amplifier in the system.
Speaker A/B Outputs: The A and B speaker out-
puts are in parallel to the amplifier output. The mini-
mum load in stereo mode is 4 ohms. This can be
used to drive up to 2 pairs of 8-ohm speakers or 1
pair of 4-ohm speakers. The minimum load imped-
ance for bridged mode operation is 8 ohms,
Speaker B only.
Stereo/Bridge Mono Switch: Sets the pair of
amplifier channels for stereo or bridge mono opera-
tion.
Line Input: The line audio input is a sensing input
that will activate the amplifier when an audio signal
from a source is present. When there is no audio
the zone will go into standby. The Left input is used
for bridged mono operation only.
AC Input: The AC voltage input for the North
American model is 120VAC at 60Hz (for the
European model, 230VAC at 50Hz). This receptacle
accepts a 3-prong IEC 320 type connector. A
detachable 3-terminal power cord is included.
1
2
3
4
5
6
7
5
R275HC AMPLIFIER
7
8