Ryobi HD1800M - Manual (Page 7)

7
SPECIFICATIONS
UNPACKING
INSTRUCTIONS
Your hammer drill has been shipped completely assembled.
■ Carefully remove the tool and accessories from the
box.
■ Make sure that all items listed in the packing list are
included.
■ Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
■ If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
APPLICATIONS
You may use the hammer drill for the purposes listed below:
■ Hammer drilling in concrete, brick, or other masonry.
■ Drilling in wood.
■ Drilling in ceramics, plastics, fiberglass, and laminates.
■ Drilling in both soft and hard metals.
■ Driving screws with screwdriver bits, using driving accessories.
■ Mixing paint.
PACKING LIST
Hammer Drill with Auxiliary Handle Assembly
Battery Pack (2)
Charger
Carrying Case
Operator’s Manual
WARNING:
If any parts are missing do not operate your tool until
the missing parts are replaced. Failure to do so could
result in possible serious personal injury.
WARNING:
The hammer drill should never be connected to a
power supply when you are assembling parts, making
adjustments, cleaning, performing maintenance, or
when the tool is not in use. Disconnecting the tool will
prevent accidental starting that could cause serious
injury.
HAMMER DRILL
Chuck ...................................................................................................................................................................... 1/2 in.
Maximum Torque ............................................................................................................................................... 350 in.lbs
Switch ....................................................................................................................................................... Variable Speed
Clutch ............................................................................................................................................................. 24 positions
Motor ................................................................................................................................................................ 18 Volt DC
Hammer Speed ..................................................................................... Low (0 - 5,200 BPM*) & High (0 - 18,200 BPM*)
No Load Speed .................................................................................................. Low (0 - 400/min) & High (0 - 1400/min)
CHARGER ASSEMBLY
Charger Input ........................................................................................................................... 120 Volts, 60 Hz, AC only
Charger Voltage ..................................................................................................................................................... 18 Volt
Charge Rate ........................................................................................................................................................... 1 Hour
* Blows Per Minute