Radio Shack 63-969 - Manual (Page 6)

6
Caution: You must use a Class 2 power source
that supplies 3 volts DC and delivers at least
200 mA. Its center tip must be set to positive
and its plug must fit the clock's DC 3V jack. The supplied
adapter meets these specifications. Using an adapter
that does not meet these specifications could damage
the clock or the adapter.
Follow these steps to connect the AC adapter to the
clock.
1. Slide the battery compartment cover in the direction
of the arrow to remove it.
2. Plug the AC adapter’s tip into the jack inside the bat-
tery compartment.
3. Route the adapter’s cord through the slot marked DC
3V on the back of the clock.
4. Replace the cover.
5. Plug the AC adapter’s other end into a standard AC
outlet.
!
63-969.fm Page 6 Monday, September 27, 1999 9:19 AM