RedMax G310TS - Manual (Page 15)

should stop immediately with the engine
at full speed. If the chain is slow to stop or
does not stop then replace the brake band
and clutch drum before use.
• It is extremely important that the chain
brake be checked for proper operation
before each use and that the chain be
sharp in order to maintain the kickback
safety level of this saw. Removal of the
safety devices, inadequate maintenance,
or incorrect replacement of the bar or
chain may increase the risk of serious
personal injury due to kickback. (SA1)
■ FELLING A TREE (SA2)
When you fell a tree, be sure to warn your
neighboring workers of the danger.
1. Decide the felling direction considering the
wind, Iean of the tree, location of heavy
branches, ease of job after felling, and
other factors .
2. While clearing the area around the tree,
arrange a good foothold and retreat path.
3. Make a notch cut one-third of the way into
the tree on the felling side.
4. Make a felling cut from the opposite side
of the notch and at a level slightly higher
than the bottom of the notch.
■ LOGGING AND LIMBING
1. Always ensure your foothold as well as
stability of the tree.
2. Be alert to the rolling over of a cut log.
3. Read the instructions in “For safe
operation” to avoid kickback of the
saw.
Before starting work, check the direction of
bending force inside the log to be cut.
Always finish cutting from the opposite side
WARNING
WARNING
8. Sawing
SA1
SA2
❲ 15 ❳