Technical data, Installation – Electrolux IG 123020 N User Manual

Page 39

Advertising
background image

Problem

Possible cause

Solution

The temperature in the
freezer is too high.

The temperature regulator is not
set correctly.

Set a lower temperature.

The door is not closed correctly.

Refer to "Closing the door".

The product temperature is too
high.

Let the product temperature de-
crease to room temperature be-
fore storage.

Many products are stored at the
same time.

Store less products at the same
time.

Products are too near to each
other.

Store products so that there is
cold air circulation.

Upper or lower square is
shown in the tempera-
ture display.

An error has occurred in meas-
uring the temperature

Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).

dEMo appears on the
Display.

The appliance is in demonstra-
tion mode (dEMo).

Keep pressed approximately
10sec the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.

Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective door

gaskets. Contact the Service Center.

TECHNICAL DATA

Dimension of the recess

Height

1225 mm

Width

560 mm

Depth

550 mm

Rising Time

24 h

Voltage

230-240 V

Frequency

50 Hz

The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.

Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:

electrolux 39

Advertising