Raypak Y-200 Series - Manual (Page 3)

Installation and Operating Manual Y-200 LonWorks Module
1
Contents
Introduction .................................................................. 1
Important Safety Instructions ...................................... 1
Installation .................................................................... 2
System Start-Up Procedure ......................................... 3
LonWorks Table of Communication .......................... 4
Alarm Chart .................................................................. 4
Limited Warranty ......................................................... 5
Introduction
The Raypak ® Y-200 ™ Series Controller with the
Echelon ® LonWorks ® Module provides the ultimate
in monitoring and control for Raypak heater applica-
tions. The LonWorks networking node can be inte-
grated with other LonWorks systems to form total
building control solutions.
The controller's LonWorks Module adheres to Lon-
Mark standards to ensure reliable and predictable
integration with other systems, and has been certified
by the LonMark Society.
IMPORTANT SAFETY
INSTRUCTIONS
IMPORTANT NOTICE: These instructions are
intended for use by qualified personnel who are spe-
cifically trained and experienced in the installation of
this type of equipment and related system compo-
nents. Installation and service personnel may be re-
quired by some states to be licensed. If your state
requires certification, be sure your contractor bears
the appropriate license. Only qualified persons shall
attempt to repair this equipment. Repair must be ac-
cording to these instructions.
WARNING: Improper installation, adjustment, al-
teration, service or maintenance may damage the
equipment, create a hazard resulting in asphyxiation,
explosion, fire, electric shock, personal injury or
property damage, and will void the warranty.
CAUTION: MORE THAN ONE (1) SUPPLY
SOURCE. THIS APPLIANCE HAS PROVISIONS
TO BE CONNECTED TO MORE THAN ONE (1)
SUPPLY SOURCE. TO REDUCE THE RISK OF
ELECTRIC SHOCK, DISCONNECT ALL SUCH
CONNECTIONS BEFORE SERVICING.
CAUTION: RISK OF ELECTRIC SHOCK. MORE
THAN ONE (1) DISCONNECT SWITCH MAY BE
REQUIRED TO DE-ENERGIZE THE EQUIP-
MENT BEFORE SERVICING.