Ryobi HP722 - Manual (Page 16)

Page 16
BATTERY REMOVAL
To preserve natural resources, please
recycle or dispose of batteries properly.
This product contains nickel-cadmium
battery. Local, state, or federal laws may
prohibit disposal of Nickel-Cadmium
batteries in ordinary trash.
WARNING:
Do not attempt to disassemble batteries. Fire or injury
may result.
BATTERY REMOVAL, PREPARATION FOR
RECYCLING MODEL HP62
See Figures 17 and 18.
TO REMOVE:
■ Lock switch trigger by placing the forward/reverse switch
in center position. See Figure 4.
■ Remove battery cover from bottom of drill handle by
depressing and pushing cover in the direction of the arrow
as shown in figure 17.
■ Slide battery assembly from drill handle enough to
expose leads and battery terminals. See Figure 18.
Disconnect leads from battery terminals.
Note: Be careful not to break battery terminals when
disconnecting leads.
WARNING:
Upon removal, cover the battery assemblies terminals
with heavy duty adhesive tape. Do not attempt to destroy
or disassemble battery assembly or remove any of its
components. Also, never touch both terminals with metal
objects and/or body parts, as short circuit may result.
Keep away from children. Failure to comply with these
warnings could result in fire and/or serious injury.
Fig. 18
DRILL
HANDLE
BATTERIES
BATTERY
LEAD
BATTERY
LEAD
TO
REMOVE COVER
BATTERY
COVER
DISPOSAL OF EXHAUSTED BATTERIES
DRILL
HANDLE
Fig. 17
RE
CYCLE
1
.8
00.822.88
37
R B R C
N i C d
Consult your local waste authority for information regarding
available recycling and/or disposal options.
For more information on battery recycling call 1-800-8
BATTERY.
SAVE THESE INSTRUCTIONS
MODEL HP62
MODEL HP62