RIDGID RV2400A - Manual (Page 14)

14
Operation (cont.)
Blowing Feature
Your vac features a blowing port. It can
blow sawdust and other debris. Follow the
steps below to use your vac as a blower.
Tug-A-Long
Hose
Blowing
Port
FORESIGHT IS
BETTER THAN
NO SIGHT
WEAR YOUR
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
WARNING: To reduce the risk of
injury to bystanders, keep them clear
of blowing debris.
1. Locate blowing port of your vac.
2. Insert the locking end of the tug-along
hose into the blowing port of the vac.
The hose should snap into place. To
remove the hose from the vac, press the
release button in the hose assembly
and pull the hose out of the vac inlet.
3. (Optional) Attach extension wand to
opposite end of hose.
4. Turn vac on and you are ready to use
your vac as a blower.
SP6636 1/10/07 9:52 AM Page 14