Ryobi 3000 PSI - Manual (Page 10)

10
ASSEMBLY
ATTACHING THE RESTING FOOT
See Figure 3.
To attach the resting foot to the pressure washer:
n Lift the mach ine sligh tly. Slide the resting foot into the
bottom of the spray wand storage tube.
n Push the resting foot into the storage tube until the base
of the machine rests in the grooves on top of the resting
foot.
ASSEMBLING THE SPRAY WAND
See Figure 4.
To attach the assist handle assembly:
n Remove the wing screw from the assist handle assembly
then s lide the spray wand assembly onto the assist handle
assembly bracket.
NOTE: The smooth side of the assist handle assembly
should be facing down.
n Position the assist handle on the ribs of the spray wand
in the desired position for the user .
n Secure the assist handle in place by tightening the wing
screw.
To attach the spray wand extension:
n Place the threaded end of the wand extension in the
connector on the end of the spray wand assembly. Push
until it snaps into place.
n Turn the connector clockwise until it stops. This secures
the wand extension in place.
n When not in use, place the assembled spray wand into
the spray wand storage.
CONNECTING HIGH PRESSURE HOSE TO
SPRAY WAND ASSEMBLY
See Figure 5.
n Uncoil the high pressure hose.
n Pull back and hold the spring loaded collar on the high
pressure hose.
n Insert the nozzle on the spray wand handle into the
collar.
n Release the collar and push until it clicks.
n Pull on the hose to be certain it is properly secured.
ATTACHING INJECTION HOSE
See Figure 6.
Before detergent can be used with this machine, the injection
hose must be attached.
n Uncoil the clear injection hose.
n Push the open end of the injection hose securely over
the barbed fitting.
n Lift the chemical bucket and push the injection hose into
the slot on the back of the bucket.
n Replace the bucket in the bucket holder.
Fig. 4
Fig. 5
SPRING
LOADED
COLLAR
PRESSURE
HOSE
SPRAY
WAND
NOZZLE
ASSIST
HANDLE
ASSEMBLY
SPRAY
WAND
EXTENSION
CONNECTOR
RIBS
SPRAY
WAND
RESTING
FOOT
Fig. 3