RCA VR616HF - Manual (Page 39)

37
programming the remote
Programming the Remote to Control an
Auxiliary component
Your remote can also control the brands of the equipment listed,
such as a radio, CD player, tape player, turntable, amplifier,
digital satellite receiver, or digital video disc player.
1. Turn on the component to be programmed.
2. Look up your component’s code number on the code
list below.
3. Press and hold the AUX button.
4. Enter the code from the code list.
5. Release the AUX button and press PWR or CHAN up or down
to see if the auxiliary component responds to the remote
commands.
Operating the auxiliary component
After you have programmed your remote, see which buttons will
operate your component.
1. Point the remote at the component, and press AUX. If it does
not turn on, press AUX and then PWR.
2. You may want to experiment to see which buttons will
operate your component. Try pressing buttons, such as PLAY,
REV, and FWD.
Auxiliary Component Codes
RCA/ProScan/Dimensia
AM/FM .......................................... 003
Auxiliary Component ................. 004
CD ................................................. 007
DVD .............................................. 010
Phono ............................................ 005
Digital Satellite Receiver ............ 008
Tape 1 ........................................... 006
Tape 2 ........................................... 009
This remote may not operate all
models of the brands that are shown.