Radian Technologies VT R800 7040 00 - Manual (Page 2)

>>> IMPORTANT SAFETY AND LIABILITY NOTICE <<<
Radial Engineering (JP Cabletek Electronics Ltd.) manufactures
products that are safe for use when connected as per the instruc-
tions in our owner’s manuals. Manuals are freely available for
download on our web sites. As it is impossible for Radial to ensure
the user is following these instructions, the user must take full
responsibility in the suitability of purchasing a Radial product for
his or her use.
For safe operation, the Headbone MUST be properly grounded, not
only to provide shielding from hum and noise, but also to prevent
any SHOCK HAZARD. The Headbone is connected to the earth
ground (AC-3rd ground pin) via its connection to Amp-1. You must
make sure that both amplifiers being connected to the Headbone
are properly grounded and equipped with a 3rd safety pin on the
AC plug. It may be unsafe to use the Headbone with vintage am-
plifiers equipped with a 2-prong plug or amplifiers whose 3rd pin
has been removed or lifted. For safety, always consult a qualified
technician on making proper connections to the equipment that
you wish to connect.
It is important to note that all Radial products that function using
AC or DC electrical current, are sold with a government agency
approved power supply for use around the world (i.e. UL, CSA etc.).
We insist that Radial products be used with equipment that carries
the same or similar safety government approvals. If you plan to use
equipment that has not been approved by a government-approved
electrical safety body, you are doing so at your own risk.
By purchasing this product, you clearly understand that you are tak-
ing full responsibility for the use of this product. If, after purchasing
this product from your dealer, you are not comfortable in accepting
this responsibility, we ask that you return the product within 7 days
to the dealer for refund, credit or exchange. Consult your dealer on
their policy regarding this matter.
Radial Engineering accepts no responsibility (consequential or
inconsequential) for damage or injury caused by improper connec-
tions, user error, using improperly grounded amplifiers, or injury
caused by failure of the Headbone or any component inside. The
use of the Headbone implies that the user/owner agrees to all of
the terms stated within this document, and has made the decision
to keep the Headbone under these terms, and waives his/her
rights to a liability claim against Radial Engineering (or associated
companies or directors) for any damage or injury caused while
using the Headbone. Please read the Headbone warranty for
further details.