RTS Digital Matrix s Keypanels DKP-8 - Manual (Page 51)

45
Menus, SERVICE MENU
Setting the Keypanel Address
1. While SET ADDR is displayed, tap the SELECT control.
ADDR 1 will appear in the call waiting window.
2. Turn the SELECT control to display the desired logical keypanel address (ADDR 1 through ADDR 10) then tap the
SELECT control.
The new setting will automatically be saved, and after a few moments, the alphanumeric displays will change from
asterisks (****) to dashes (----).
3. Double-tap the SELECT control to return to the previous menu level. Or, press and hold the SELECT control for two
seconds to exit menu mode.
Menus, SERVICE, SIDETONE
When you are using headphones that completely cover the ears, the sidetone feature lets determine if you want to have
sidetone on constantly or not and lets you adjust the level of your own voice in headphones to eliminate the muffled sensation
when talking over the intercom. This feature also adjusts the chime level.
To set when Sidetone is activated, do the following:
1. In the SERVICE menu, turn the SELECT control to display Sidetone, then tap the SELECT control.
2. Turn the SELECT control to display either Always ON or Switched.
Always ON means sidetone will always run whether you are talking or not. Switched means that Sidetone will only be
activated when the Talk key is pressed.
3. Double-tap the SELECT control to return to the previous menu level. Or, press and hold the SELECT control for two
seconds to exit menu mode.
To Adjust the level you hear, do the following:
1. Activate a talk key, then tap SIDETONE.
2. Speak into the headset microphone while turning the SELECT control to adjust your voice level, as desired.
Remember to save your changes if you and them retained for future use. See “Menus, SERVICE, SAVE CFG” on page 44..
Menus, SERVICE, TALLY
You can set the amount of time that the displays will flash for incoming calls as follows:
1. In the SERVICE menu, turn the SELECT control to display TALLY, then tap the SELECT control.
2. Turn the SELECT control to display any of the following time periods (in seconds), then tap the SELECT control.
(5 SEC, 10 SEC, 15 SEC, or EXTEND) If you select EXTEND, displays will flash continuously for incoming calls until the
calls are answered.
3. Double-tap the SELECT control to return to the previous menu level. Or, press and hold the SELECT control for two
seconds to exit menu mode.
Remember to save your changes if you want them retained for future use. See “Menus, SERVICE, SAVE CFG” on page 44..
Menus, SERVICE, TEST PNL
TEST PNL lets you check operation of indicators and controls.
When you select TEST PNL, the following sequence will occur:
• All alphanumeric displays will display% symbols to verify display operation.
• All tri-color indicators will flash green-yellow-red-off. All single-color indicators will flash green-off. This verifies
the operation of all indicators displays.