Realistic 120-1451 - Manual (Page 5)

REALISTIC Stereo Three AM/FM Radio
(120-1451) Operation Faxback Doc. # 18907
Be sure all equipment is connected as described previously and as shown in
the illustration. Do not operate the Stereo Three without speakers
properly connected.
Extend the AC line cord to its full length (to assure maximum benefit from
the FM Line Cord Antenna) and plug it into a source of 120 volts, 60 Hz AC
power.
AM Reception
1. Set the Selector switch to AM.
2. Turn VOLUME in a clockwise direction to turn power "on".
3. Adjust Tuning control to the station you want to listen to, as
indicated on the slide rule tuning dial.
4. Adjust VOLUME, TONE and BALANCE for best sound.
FM Reception
1. Set the Select or switch to FM.
2. Turn VOLUME in a clockwise direction to turn power "on".
3. Adjust Tuning to the desired station as indicated on the slide rule
tuning dial.
The built-in AFC circuit (automatic frequency control) will
automatically lock-in the station for drift free reception.
The Stereo Indicator Light will automatically light up when you are
tuned to a station which is broadcasting a stereo signal.
4. Adjust VOLUME, TONE and BALANCE for the best sound.
PHONO Operation
1. If you have cables connected from a Record Changer/Turntable to the
PHONO jacks on the rear of the unit, set the Selector switch to PHONO.
2. Turn power "on" using the VOLUME control.