Radio Shack 16-3313 - Manual (Page 9)

Ba
sic In
sta
llat
ion
9
BASIC INSTALLATION
For a graphical view of the installation, see the Quick Start.
I
NSTALLING THE
DVD P
LAYER
IN A
V
EHICLE
1. Make sure the DVD player is securely fastened in the
carrying case.
2. Pull down the panel on the back of the carrying case
and reattach it, aligning the velcro strip to the catch
panel.
3. Attach one of the supplied straps to the carrying case
and hang the strap over the back of the headrest.
4. Attach one strap to each loop on the bottom of each
side of the carrying case.
5. Wrap the straps around the bottom front of your seat
and attach them together. The configuration varies
depending on your car seat.
6. Secure the DVD player by adjusting the straps to the
appropriate length for your car seat.
C
ONNECTING
V
EHICLE
B
ATTERY
P
OWER
You can power the DVD player from your vehicle’s 12V
power source (such as a cigarette-lighter socket) using the
supplied DC adapter.

1. Unzip the middle zipper on the carrying case to insert
the adapter plug into the jack.
2. Connect the supplied DC adapter cord’s barrel plug to
the DC IN jack on the back of the DVD player.
3. Connect the other end of the adapter to the vehicle’s
cigarette lighter socket.
!
C ONNECTING H EADPHONES
The DVD player has two 1 / 8 -inch (3.5 mm) headphones
jacks on the right side of the screen panel for private
listening. Connect the supplied stereo headphones’
1 /
8
inch (3.5 mm) plug(s) into the s 1 and/or s 2 jack(s). Ô

CAUTION

• You must use a power source
that supplies 9V–12V DC and
delivers at least 1.2A. Its center
tip must be set to positive and its
plug must fit the DVD player's
DC IN 9V–12V jack. The
supplied adapter meets these
specifications. Using an adapter
that does not meet these
specifications could damage the
DVD player or the adapter.
! IMPORTANT !
To avoid draining your car’s
battery power, do not leave the
DVD player on or the DC adapter
connected to the cigarette lighter
when your vehicle is not running.
Ô
NOTE
Ô
The built-in speakers are disabled
when you plug a headphone into
s 1, but not when you plug a
headphone into s 2.