Regency P40 - Manual (Page 47)

Regency ® P40-1 Direct Vent Gas Fireplace 47
MAINTENANCE
MAINTENANCE
1) Unplug the power source.
2) Remove the manual control panel by
removing the 2 screws.
3) Remove the DC Sparker by removing the 2
screws that secure the DC Sparker to the
fi rebox and lift out.
DC Sparker
4) Remove the cover on the DC Sparker and
unplug the red (+) and black (-) wires.
Note: Ensure that the ring tabs on the wire
fi t behind the metal posts when re-
installing.
5) Unplug pilot knob wires (Wa and Wb) and
ignitor wire (Vu).
DC SPARKER
REPLACEMENT
Ring Tabs
6) Replace the DC Sparker and reverse steps
to re-install.
Wa & Wb Wires Vu Wires
Manual Control Panel
1) Unplug the power source.
2) Remove the Power Module by lifting it up off
of the velcro and pull out.
Power Module
3) Remove the Power Module cover by
removing the 2 screws, one on each side
of the box.
4) Unplug all wires connected to the Power
Module (J1, J2 & J3 on the power module
circuit board).
5) Pull Power Module off of pins and replace.
6) Reverse steps to re-install.
POWER MODULE
REPLACEMENT
J1
J2
J3