RocketFish RF-AHD25 - Manual (Page 9)

9 RF-AHD25
Connecting the enclosure to your computer
Notes:
Connect the enclosure with your computer either through a
USB or eSATA connection. If you are using an eSATA
connection, the AC adapter is required.
The enclosure provides USB and eSATA dual interface for
host connectivity. The high-speed eSATA port has priority
over the USB port when both are connected at the same
time.
To connect the enclosure to your computer:
1 Plug one end of a USB 2.0 cable or eSATA cable to the
enclosure, then plug the other end of the cable to your
computer.
2 Plug one end of the power adapter into the enclosure,
then plug the other end to an AC outlet if you are using
eSATA mode.
The operating system automatically detects and sets up
the new drive.
Installing the backup software
Note: This Roxio BackOnTrack software only runs on
Windows XP and Windows Vista PCs using USB mode.
Before installing the backup software, make sure that your
Windows operating system has been updated to the latest
service pack. To make sure you have the lasted service pack,
run Windows Update. No additional driver is required.