Roland DB-700 - Manual (Page 10)

10
Connect your DB-700
Refer to the following diagram and connect the DB-700 to the external eqipment you are using.
fig. 5 (connection with an external instrument)
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
* The pin assignment for the XLR type connectors is as shown
below. Before making any connections, make sure that this pin
assignment is compatible with that of all your other devices.
fig.6 (XLR jack polarity diagram)
Turn the power on and off
Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
- Effecter -> DB-700 -> others output eqipment
* The heat-dissipation fins on the back of the unit become hot
while the equipment is in operation. Do not touch them!
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
* Always make sure to have the volume level turned down before
switching on/off power. Even with the volume all the way down,
you may still hear some sound when the power is switched on/
off, but this is normal, and does not indicate a malfunction.
* Although activation of the heat-protection circuitry, which
occurs when the amp is used in overly hot weather or other such
conditions, may result in interruptions of the sound, this does
not indicate a malfunction.
INPUT OUTPUT
Foot switches
or
Power amplifier
Effecter
Mixer
1 2
3
1 : GND (earth)
2 : HOT
3 : COLD